Installation – Niles Audio IRH610 User Manual

Page 4

Mounting Location

The IRH610 is specifically designed to conveniently fit
into a structured wiring cabinet with snap-in
“Christmas Tree” plugs or it can also be wall mounted
in an unobtrusive location.

Installation

1. Run all necessary wiring to the IRH610. Label the

wires for future reference.

2. Secure the IRH610 in a suitable location.

• In a structured-wiring cabinet, use the conven-

ient snap-in “Christmas Tree” plugs (supplied) to
mount it in the cabinet frame.

• On a wall or other flat surface, remove the snap-

in plugs, insert drywall screws (not supplied)
through the resulting holes, and secure the
screws to the mounting surface. TAKE CARE
NOT TO OVERTIGHTEN THE SCREWS, WHICH
COULD DAMAGE THE HOUSING.

3. Locate the connector plugs

(and remove them if they
are plugged in).

4. Strip 1/4" of insulation from

the end of each wire.

5. Use a small flathead screw-

driver or your thumbnail to
raise the locking tabs,
exposing the holes on the
removable connector plug.

6. Insert each wire into the

appropriate hole on the
removable connector plug, and snap the locking
tab down.

NOTE: To help you, the connector plug is keyed.
Insert the smooth side of the connector plug into
the smooth side of the socket. Don’t force the
scalloped side of the connector plug into the
smooth side of the socket.

P A

Figure 2

DS00351ACN/IRH610 12/11/03 4:57 PM Page 5