NISSAN 40053 - Manual (Page 3)

3 ‘04-’09 Nissan Titan - Kit 40053
b. Remove airbag fuse.
c. Strap steering wheel to prevent accidental
movement.
Prepare to Install Kit
Front of vehicle
1. SE & LE models: Front bumper
a. If equipped, remove two wiring harness connec-
tors from running lights.
WARNING
Accidental deployment of the air bag can result in seri-
ous personal injury or death. To avoid accidental
deployment during installation of the lift kit, the Supple-
mental Restraint System (SRS, or airbag) must remain
deactivated. Do not allow anyone near the airbag dur-
ing installation. Refer to the factory service manual or
owner's manual for the recommended procedure to
disable the SRS. After kit installation, the SRS must be
reactivated before driving the vehicle.
CAUTION
If the following step is not performed, the airbag clock-
spring could be damaged. Do not turn the steering
wheel while the steering shaft is disconnected.
Fuse Cover
Airbag Fuse
Running
Lights
Wiring
Harness
Connector
b. Remove four bolts and skid plate from frame and
vehicle.
c. If equipped, remove four bolts and two tow
hooks from frame.
d. Remove four bolts and two side impact braces
from frame.
e. Remove four nuts and two side impact braces
from front bumper.
Bolts
Frame
Skid Plate
Tow Hooks
Bolts
Frame
Side Impact
Braces
Bolts
Frame
Side Impact
Braces
Nuts
Front
Bumper