beautypg.com

Quick start – NEC MULTISYNC LCD195WVXM User Manual

Page 5

background image

3

To attach the Base to the LCD Stand:

. Insert the front of the LCD Stand into the holes in the front of the Base (Figure 1).
2. Attach the Base to the Stand. The locking tab on the Base should fit into the hole on the back

of the Stand.
3. Attach the Cable Holder onto the Base (Figure 2). Insert the hooks on the Cable Holder into

the holes at the back of the Stand and slide the Cable Holder downward into place.

Locking Tab

Base

Stand

Figure

Figure 2

To attach the MultiSync LCD monitor to your system, follow these instructions:

. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the

connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 5-pin mini D-SUB signal cable to the connector of the

display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 5-pin

mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.3). Tighten all screws.

NOTE: To obtain the MultiSync Macintosh cable adapter, call

NEC Display Solutions of America, Inc. at (800) 632-4662.

3. Connect the5-pin mini D-SUB cable to the appropriate connector on the back of the monitor. (Figure

B.1) Connect one end of the audio cable to AUDIO-INPUT on the back of the monitor and the other end

to the “Audio Out” terminal on the computer. Headphones may connected to the “Headphones” output,

“ ”, on the front of the monitor. While headphones are connected, the sound from the speakers will

be disabled.

NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use

section of this manual for proper selection of power cord.

4. Connect one end of the power cord to the LCD and the other end to the power outlet. Place the video

signal cable, power cord and DVI cable into the cable holder (Figure B.1).

NOTE: Adjust the position of cables in the cable holder to avoid damage.
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use

section of this manual for proper selection of power cord.

5. Turn on the monitor with the front power button and the computer. (Figure C.1)
6. No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most

timings. For further adjustments, use the following OSM

®

controls:

• Auto Adjust Contrast • Auto Adjust
Refer to the Controls section of this User’s Manual for a full description of these OSM controls.
NOTE: For download information on the Windows

®

95/98/Me/2000/XP INF file for

your MultiSync monitor, refer to the References section of this User’s Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of this

User’s Manual.

Quick Start

This manual is related to the following products: