NAD C370 User Manual

Page 9

TROUBLESHOOTING

NO SOUND

• Power AC lead unplugged or power not

switched on

• Tape 1 Monitor selected
• Mute on
• Rear Pre-out/Main-in amp links not fitted
• No speakers selected

• Check if AC lead is plugged in and

power switched on

• De-select Tape 1 Monitor mode
• Switch off Mute
• Fit links
• Select the appropriate speakers (A / B)

Problem

Cause

Solution

NO SOUND ONE CHANNEL

• Balance control not centred
• Speaker not properly connected

or damaged.

• Input lead disconnected or damaged

• Centre Balance control
• Check connections and speakers

• Check leads and connections

WEAK BASS /
DIFFUSE OR NO STEREO IMAGE

• Speakers wired out of phase

• Bridge Mode selected when speakers

are connected normally

• Check connections to all speakers in

the system

• Disengage Bridge Mode

REMOTE CONTROL HANDSET NOT
WORKING

• Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows

obstructed

• IR receiver in direct sun or very bright

ambient light

• Check or replace batteries
• Remove obstruction

• Place unit away from direct sun, reduce

amount of ambient light

POWER/PROTECTION LED STAYS RED
UPON TURNING POWER ON

• Loudspeakers cabling has a short-

circuit

• Turn amplifier off and check

loudspeaker cable connections for both
speakers at amplifier's back panel and
loudspeakers. Turn amplifier on.

POWER/PROTECTION INDICATOR TURNS
RED DURING OPERATION

• Amplifier has over-heated.
• Overall impedance of loudspeakers too

low

• Turn amplifier off. Make sure

ventilation slots on top and bottom of
amplifier aren't blocked. After amplifier
has cooled down, turn back on.

• Ensure the overall loudspeaker

impedance isn't below 4 ohms.

• Check loudspeaker cables for short

circuits

7. TUNER CONTROL
(for use with NAD Tuner)
BANK

Selects a bank of preset stations.

PRESET

selects respectively higher or lower

number station preset.

8. CD PLAYER CONTROL
(for use with NAD CD Player)

engages Pause
engages Stop
engages Play or toggles between Play and Pause
or

engages Track skip; Press once to respectively go to

the next track or to return to start of current or previous track.
NEXT DISC

Go to next disc (for NAD CD changers).

9. CASSETTE DECK CONTROL
(for use with single (DECK B) or double transport (A and B) NAD
Cassette Decks).

engages Forward Play or Reverse Play.

Record / Pause. Press to put cassette deck into record-

pause. Press Play to start recording.

Stops Play or Recording.
engages Rewind.
engages Fast Forward.

NOTES:

The remote control handset supplied with the C370 is of

a universal NAD type, designed to operate several NAD models.
Some buttons on this handset are inoperative as the functions
aren't supported by the C370. The Video 2 and Video 3 input
selector buttons (inside section No. 5) on the remote control
handset are inoperative in the case of the C370.

Direct sunlight or very bright ambient lighting may affect the
operating range and angle for the remote control handset.