Nostalgia Electrics SCC-200 - Manual (Page 6)

ENGLISH 5
ASSEMBLY (Continued)
3.
Connect the Base Supports by screwing two of the #1 screws into the Cross Bar
(as shown below):
4.
Connect the Leg Assembly by screwing four of the #3 studs from the Base
Support into the Leg Assembly (as shown below). Make sure to screw from the
Base Support into the Leg Assembly and not vice versa. Once the studs are
firmly screwed through, place the four #8 Nut Caps over the studs for cosmetic
purposes:
5.
Now that the Leg Assembly and Base Support have been connected, use four of
the #2 screws to connect the Storage Compartment to the Base Support (as
shown below). Once you have successfully screwed the #2 screws through the
Storage Cabinet and into the Base Support, place the Bottom Plate underneath
the Storage Cabinet and attach it to the Base Support using four of the #1
screws: