Net Optics ISW-CU3-S4x16 - Manual (Page 11)

7
4xN 10/100/1000 Span iMatrix Switch
Figure 9: Connecting to the CLI
3. Launch your terminal emulation software and set the communication
parameters to:
19200 baud
8 data bits
No parity
1 stop bit
No fl ow control
3. Connect power to the iMatrix Switch. The CLI banner and login prompt
appears.
Figure 9: Login and Password Prompts
4. Type netoptics and press Enter.
5. At the password prompt, type netoptics and press Enter. The NetOp-
tics: prompt appear.
To change the username and password:
1. Change the username by typing the following command:
set username
where is your new username.
*************************************
* Net Optics Command Line Interface *
*************************************
Login:
Password:
DB9 Control Port 2
To COM port on monitoring device or computer
CONTROL PORT 2 CONTROL PORT 1
OFF
1 3 4 5 6 7 8 2