National Mower Triplex-CE DL 68" - Manual (Page 9)

NATIONAL 68" SR & DL TRIPLEX – CE ®
9
FIGURE A
CAUTION
Claims for shipping damages must be noted by the
consignee at the point of destination and filed with the
transportation company that delivers the shipment.
CAUTION
INTRODUCTION
This machine has been designed to meet European
CE Safety Standards. Metric eqivalents are provided
wherever possible for users outside the United States.
This manual has been prepared by National Mower
Company as an aid to users for assembly, maintenance,
adjustment and ordering replacement parts. Additional
information will gladly be furnished by calling or writing the
manufacturer or his authorized agent.
Please furnish us with the Model Number, Serial
Number and Date of Purchase when contacting us about
your machine. Designations of right, left, front and rear
are used as if the operator was sitting in the mower seat.
NOTE
4. Lift Rear Mower (4, Fig. A) off the crate supporting
members and set aside for later attachment.
Handle mowers carefully with protective gloves.
Reels rotate freely and are very sharp.
5. Make sure Wing Mowers (5, Fig. A) are secure to the
mower frame with Wing Mower Hooks (15, Fig. B).
6. Knock down all sides of crate and remove. Roll mower
backwards off of crate base.
UNCRATING INSTRUCTIONS
RECEIPT OF SHIPMENT
Carefully inspect your machine and crate for dam-
age that could have occured during shipment. If damages
or shortages are noted, have the transportation company’s
representative note this on the bill of lading.
In order to prevent possible damage to the machine or
personal injury, the following uncrating procedure must
be followed:
1. Position Crate 1 as shown in Figure A, on a hard, level
surface.
2 Cut and remove all Steel Banding (2, Fig. A).
3. Remove the entire top of the crate. Unbolt Seat (3,
Fig. A) from crate bracing and lay seat aside for
installation later. Save the bolt and washer to use for
mounting the seat mounting member.