NEC E1100+ - Manual (Page 5)

Quick Start
3
To attach the MultiSync ® E 1100 + ™ monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter to the monitor connector
on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the
captive signal cable to the Macintosh cable adapter on the computer (Figure
B.1)
. Tighten all screws.
4. For download information on the Windows ® 95/98 INF file for your MultiSync
E 1100 + monitor, refer to the References section of this User’s Manual.
5. Connect one end of the power cord to the MultiSync E 1100 + monitor and the
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
Figure A.1 Figure B.1
78133724.wpc 11/18/98, 11:52 AM 5