NEC GPRS Dial Up 1.1 - Manual (Page 11)

8
Connecting the NEC USB Cable To the NEC Wireless Phone
Before installing the USB drivers, connect the USB cable to your computer and the NEC
Wireless Phone.
1. Find the location of the USB port on your computer.
2. Insert the computer end of the USB cable into the computer’s USB port.
3. Gently squeeze the release clips on each side of the USB plug and insert the plug into
the adapter port of the NEC Wireless Phone.
• Be sure that the rectangular opening on the connector is lined up with the
rectangular opening in the phone. The plug will slide easily into the opening. DO
NOT FORCE THE PLUG!
Plug into USB Port
on PC
Insert
Release
Clips
4. Press the (End/On-Off) key to power-on the NEC Wireless Phone. New hardware
found message box displays.
NOTE: Check that the NEC Wireless Phone’s battery level icon in the status bar of the
Idle screen shows to be fully charged.
The USB cable does not charge the phone’s battery.