Ncomputing vspace software installation – NComputing VIRTUAL DESKTOP KIT U170 User Manual
Page 12
USB Virtual Desktop (Model U170) User Manual
Page 12
NComputing vSpace Software Installation
This user manual applies to vSpace 4, 5 and 6 for Windows. Note that screen shots included
below for reference may vary slightly depending on the version of vSpace and the operating
system you are installing.
IMPORTANT! Per the instructions below, always check the NComputing website for the latest
vSpace software. The software on the CD in your package may not be the latest version.
You can view a chart specifying which version of vSpace is the latest for which operating
system in the NComputing Knowledge Base
by searching
on “vSpace Operating System Support Matrix.” Or click directly on this link:
You can download the appropriate version by visiting the Software Download Center
– note that the software download center
will include Release Notes specific to that release
– it is very important to read these
release notes prior to installation.
In addition, the latest version of this user manual is posted on the Documentation page
in the Support section of the websit
Perform the simple steps below to install the vSpace software on the host PC.
1. Run the installation software that you downloaded from the NComputing Software
Download center. (Use the CD installer, only if you do not have internet access).
2. Follow the directions in the install wizard to complete the software installation.
3. Reboot the system.
4. Connect U170 devices to the PC.
5. The Windows operating system will discover the new devices and display the prompt
“Can Windows connect to Windows Update to search for software?” Select “No, not this
time.” (Note: USB discovery can take some time. During the FIRST install only you will
be asked to repeat this discovery for each U170 connected to the host PC. If installing
multiple devices, please be patient during the discovery process.)