Niles Audio BG525 User Manual

Page 14

Installation of
Brackets, Frames
and Grilles in New
Construction

Stage One: Before Drywall is Hung

Insulating the Wall Cavity.
If feasible, fill the wall cavity with insula-
tion at this point.

Attach the wings to the bracket by snap-
ping them into the sides of the bracket.
The wings can be shortened by breaking
them along the scored lines if their length
will interfere with a corner or eaves. You
can mount the bracket horizontally or ver-
tically (See Figure 8).

Screw one side of the assembled bracket
with wings to the stud using one of the
supplied screws. Level the bracket. Screw
the other side of the bracket to the stud.
Two screws on each side makes for a very
secure installation. Attach the wire to the
bracket at the indicated wire tie points
(See Figure 9)

Stage Two: Before Paint
Screw the frame to the installed bracket
using the supplied screws. Do not over-
tighten the screws. This will distort the
frame and the grille will not fit (this is not
permanent, just loosen the screws and the
grille will pop in) (See Figure 10).

Painting the Aluminum Grilles
The grille is important to the sound of the
BG loudspeakers. Do not fill the holes of
the grille with paint. The grille is construct-

Inst
allation

ack
et

s, F
rames and Grilles in Ne

w Constr

uction

Figure 8