Nortel Networks AKM9600/8 - Manual (Page 9)

B
8 in (20 cm)
5.Place the keyboard and the mouse
in the proper location for your
computer.
Note! Refer to the section on
ergonomics later in the quick
guide for more information on
setting up your workstation.
6.Turn on the computer.
7.Press the Receiver connect button a
(don't hold it down), then press the
Mouse connect switch within 3
seconds. Mouse ID will link in
success.Repeat to press the
Receiver connect button, then press
the Keyboard Connect switch withon
3 seconds,keyboard ID will link in
success.
4.Place the RF receiver in a good
location. Place the receiver at least
8 inches (20 cm) from
electrical devices such
as the computer or monitor.
Ensure that the mouse and keyboard are working. If they do not respond,pls.move the
mouse or press keystrokes. If not working yet,pls. keep intermission for 15 seconds
at least,then repeat Step 7 to ensure that a connection has been made.For any further
solution, pls.take refer to the Troubleshooting section at the end of this guide.
A
Receiver
connect button
Connect
switches
C
6