NuTone NC300 series - Manual (Page 6)

models nm 100 • nc 300
Page
• Talk
Talk to all remote stations set to Intercom or Radio/INT.
• Speaker Volume
Use Speaker Volume knob to adjust the remote speaker
volume.
• Music Volume
turn music source on and off
You can turn the Music Source on and off from the
NRS104WH or the NPS104WH Remote Station.
To turn the Music Source on, press and hold the MUSIC
VOLUME UP button.
To turn the Music Source off, press and hold the MUSIC
VOLUME DOWN button until the volume level goes to zero.
adjust system music volume
Adjust the system music volume from any Remote Station by
pressing VOLUME UP or VOLUME DOWN.
• select music source
The system music source can be selected from any Remote
Station. The music sources that are available vary depending
on the Scan setting on the Master Station (See Master Station
Settings/Music Settings/Scan Mode for details).
Note: You cannot select specific tracks on the CD from a
Remote Station.
To scan for a music source:
Simultaneously press and release VOLUME UP and
VOLUME DOWN to switch music sources.
Note: If you press and hold these buttons for 4 seconds or
more, you initiate the Security/Home Automation function
(See Intercom Operation/Security/Home Automation for
details). This function is not available on the Outdoor Remote
Station.
remote station operation 3-wire (nutone retrofits)
remote station functions
• Door
Press Door to talk to the Door Station. Release button to
listen to the Door Station.
• Remote
Press Remote to talk to Remote Stations. Remote Stations
press Talk to reply.
• Speaker Volume
Use Speaker Volume knob to adjust the remote speaker
volume.
• Music Volume
turn music source on and off
You can turn the Music Source on and off from the Remote
Station.
To turn the Music Source on, press and hold the MUSIC
VOLUME UP button.
To turn the Music Source off, press and hold the MUSIC
VOLUME DOWN button until the volume level goes to zero.
adjust system music volume
Adjust the system music volume from any Remote Station by
pressing VOLUME UP or VOLUME DOWN.
• select music source
The system music source can be selected from any Remote
Station. The music sources that are available vary depending
on the Scan setting on the Master Station (See Master Station
Settings/Music Settings/Scan Mode for details).
Note: You cannot select specific tracks on the CD from a
Remote Station.
To scan for a music source:
Simultaneously press and release VOLUME UP and
VOLUME DOWN to switch music sources.
Note: If you press and hold these buttons for 4 seconds or
more, you initiate the Security/Home Automation function
(See Intercom Operation/Security/Home Automation for
details). This function is not available on the outdoor remote
station.