Chapter iii. installation – NexxTech USB Web Camera User Manual
Page 6
4
Chapter III. Installation
Get Ready To Install Your USB Web Camera
1. USB Web Camera
2. USB Web Camera Setup/Application CD-ROM
Install Your USB Web Camera
1. Turn on your computer or Notebook PC. Close all the programs that run under the Windows system.
2. Load the USB Web Camera Setup/Application CD-ROM into your CD-ROM drive.
3. Follow the on-screen instructions given by the installation program to complete the USB Web Camera installation.
(If the auto-run program has not started, choose Start and Run, type ‘E:/Setup.exe’ at the Open column to start
installation.)
4. After the ‘USB CAM’ application has been installed successfully, connect the end of the USB cable of your PC
Camera into the USB port of your computer or Notebook PC.
Connect Your USB Web Camera to Your Computer
Your USB Web Camera is now set up and ready to use. At this point, you may wish to run ‘USB CAM’, the USB Web
Camera software to begin using the USB Web Camera. Please refer to the next chapter Using the USB Web Camera for
more information.