National Geographic 264NE - Manual (Page 3)

(
Indoor/Outdoor
Wireless Thermometer With RCC Clock
Instruction Manual
Monitor:
A. Time
B. Date
C. Battery Icon
D. Indoor Temperature
E. Signal Detection Icon
F. Outdoor Temperature
G. RCC Icon
H. Alarm Icon
I. Wave OK Icon
1. Max./Min. Button
2. Alarm Button
3. Clear Button
4. Snooze/Light Button
5. (+) Button
6. Set Button
7. (-) Button
8. Wave Button
9. Re-Sync Button
10. DST/Time Zone Button
11. ºC/ºF Button
12. Reset Button
Remote Sensor:
13. Reset Button
Before You Begin
1.0 Set up procedure:
1. Insert batteries into the monitor first and then press the RESET button once.
2. Place the monitor as close as possible next to the remote sensor and insert the
batteries into the remote sensor and press the RESET button.
3. Position the monitor and remote sensor within effective transmission range, which
in usual circumstances is 20 to 45 meters. The range is affected by the building
materials and where the monitor and remote sensor are positioned; try various
locations for the best results. (See section 3.1).
Note: The remote sensor should be placed in a shaded area for accurate readings
1.1 Getting Started
Once the remote sensor has been powered up (or the RESET button has been
pressed), the transmission signal is immediately sent to the monitor. The monitor will
attempt to search for the signal for 5 minutes.
Once the signal is received, the dashes (--.-°F) on the monitor will change to the
current outdoor temperature. If after 5 minutes the screen does not change to show
the outdoor temperature, press the RE-SYNC button on the monitor. The monitor will
now attempt to search for the signal for another 6 minutes.