Nady Systems PPA-300 - Manual (Page 7)

7
S P E C I F I C AT I O N S
The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design
and appearance, are subject to change without prior notice.
POWER SPECIFICATIONS
OUTPUT POWER (EIA 1KHz 1% THD) ..................................................................................120W RMS @ 8
Ω
per side
150W RMS @ 4
Ω
per side
ELECTRICAL SPECIFICATIONS
INPUT SENSITIVITY ...........................................................................................................................500V RMS (-4dBu)
INPUT IMPEDANCE ..........................................................................................................50K
Ω
Unbalanced & Balanced
FREQUENCY RESPONSE (at 10dB below rated output power) ........................................................20Hz~20KHz ±1dB
5Hz~50KHz ±3dB
DISTORTION ..............................................................................................................................................................<.1%
S/N RATIO ................................................................................................................................................................100dB
GENERAL SPECIFICATIONS
PROTECTIONS ......................................................................Full short circuit, open circuit, thermal, ultrasonic, and RF
protection; stable into reactive or mismatched loads; ON/OFF muting; current limiter
FRONT CONTROLS ............................................................................Power switch, input level control for each channel
REAR PANEL CONTROLS ......................................................................................................AC voltage selector switch
CONNECTORS ......................................................................................................................Power; IEC power cord jack
Input: Active balanced XLR and 1/4” (6.3mm) TRS
Output: dual 1/4” speaker jacks
POWER SUPPLY ..................................................................................................................................110V~120V 60 HZ
FUSE ............................................................................................................................................115V AC ~ 4A 250V FB
DIMENSIONS ..........................................................................................................19” x 9.6” x 3.5” (483 x 244 x 89 mm)
WEIGHT ....................................................................................................................................................16.6 lbs. (7.5Kg)