Nilfisk-Advance America SW 700S P - Manual (Page 62)

ENGLISH USER MANUAL
20 146 0676 000(5)2007-06 A SW 700S P
TROUBLESHOOTING
Trouble Possible cause Remedy
The engine does not start when pulling the
handle.
The ignition key is not turned to “I”. Turn the ignition key to "I".
The engine oil level is low. Add engine oil. (1)
The fuel tap is closed. Open the fuel tap.
The fuel tank is empty. Refuel.
The hood is not properly closed. Close the hood properly.
The fuel does not reach the carburettor. Check if the fuel reaches the carburettor. (1)
The spark plug does not produce a spark. Clean/replace the spark plug. (1)
The engine stops during operation.
The engine oil level is low. Add engine oil. (1)
The fuel tank is empty. Refuel.
The side broom does not operate.
The side broom is not lowered. Lower the side broom.
The side broom belt or belt tensioner is not
effi cient. Contact an authorised Nilfi sk-Advance
Service Center.
When pulling the drive lever, the machine does
not move, or it moves slowly.
The pedal brake (optional) is engaged. Release the pedal brake (optional).
The driving belt tensioner is not operating.
Contact an authorised Nilfi sk-Advance
Service Center.
The driving belt is not effi cient.
Contact an authorised Nilfi sk-Advance
Service Center.
(1) For the relevant procedure, see the Petrol Engine Manual.
For further information, refer to the Service Manual, available at any Nilfi sk-Advance Service Center.
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
Polyester dust fi lter
Main and side brooms
Engine oil
Plastic hoses and components
Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
–
–
–
–
–