Scsi chain connection with other devices, Connecting the scanner – Nikon AX-110 User Manual
Page 31
Nikon
ScanTouch 110 User's Manual
21
SCSI Chain Connection with Other Devices
If your ScanTouch is connected at the end of the SCSI chain, install the
supplied terminator to the other SCSI connector on the rear of
ScanTouch. If your ScanTouch is connected between the other SCSI
devices, no terminator on ScanTouch is necessary.
Since the terminator is built into the host computer in most cases, the
host computer should be at the end of the SCSI chain. Some notebook
computers require a terminator to be attached outside the computer;
please refer to the operation manual for the computer.
Note:
The SCSI cable used for SCSI connection should be of high-
impedance type.
Terminator
Terminator
ScanTouch
the other SCSI device
ScanTouch
the other SCSI device
ScanTouch
the other SCSI device
ScanTouch
the other SCSI device
4. Connecting the Scanner