Newcon Optik NEWCON LRB 7X50 - Manual (Page 6)

Made in Canada
Newcon Optik
Patent pending
1 – Eyepieces; 9 – Interpupilary distance adjustment lever
10- Identification Label (Located on the Bottom)
Fig. 2
3. SUPPLIED ACCESSORIES
LRB 7X50 is supplied in the following assembly:
- Device
- Carrying Case
- Neck Strap
- User’s manual
- Warranty card
- 9V battery (optional) 1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
• TARGET REFLECTION MED - when the number of
steady received reflected signals is in medium range and
enough to make positive conclusion about the measured
distance;
• TARGET REFLECTION HIGH - when the number of
steady received reflected signals is qualified to be enough to
make reliable conclusion about the measured distance.
The displayed statistical qualification of the reflected signal
characterizes variation in expected accuracy of measurements. At
qualification HIGH the accuracy of measurements is stated as
± 1m or ± 0.1%. At lower rates of statistical qualification the
expected accuracy may marginally degrade.
Please note: this is an optional feature.
The display presents message LOW BAT – when voltage of the
primary 9-volt battery drops below 7.2 volt. At this point the
System is still functional but the battery should be replaced as
soon as possible. The system can operate at the voltage levels
above 7 volts.
The System remains in the active displaying state for 10 seconds
after pressing of any of the operating buttons and after 10 seconds
enters the passive low power state.
Alkaline or lithium type of batteries capable to sustain current
drain up to 150 ma should be used for powering the System.
1
9
10