Unpacking and setup, Connecting am antenna – NAD T744 User Manual

Page 6

UNPACKING AND SETUP

Packed with your T 744 receiver you will find:

• An AM loop antenna
• A FM ribbon-wire antenna with balun
• A removable AC cable (if you wish, any IEC-standard AC cable of suitable wattage may be substituted).
• The HTR 2 remote control with 4 (four) AAA batteries.
• This owner’s manual.

Save the packaging
Please save the box and all of the packaging in which your T 744 arrived. Should you move or otherwise
need to transport your receiver, this is by far the safest container in which to do so. We’ve seen too many
otherwise perfect components damaged in transit for lack of a proper shipping carton, so please: Save that
box!

Choose a location that is well ventilated (with at least several inches to both sides and behind), and that will
provide a clear line of sight, within 25 feet/8 meters, between the receiver’s front panel and your primary
listening/viewing position—this will ensure reliable infrared remote control communications. The T 744
generates a modest amount of heat, but nothing that should trouble adjacent components. It is perfectly
possible to stack the T 744 atop other components, but the reverse usually should be avoided. Nonetheless,
it is generally preferable that the T 744 stand alone. It is especially important that sufficient ventilation be
provided; if you are contemplating locating the T 744 within a cabinet or other furniture, consult your NAD
audio/video specialist for advice on providing adequate airflow.

CHOOSING A LOCA

CHOOSING A LOCATION

TION

WHA

WHAT’S IN THE BOX

T’S IN THE BOX

1 Rotate the outer frame of the antenna.

2 Insert the bottom edge of the outer frame into the groove on the stand.

3 Extend the antenna cord.

ASSEMBLING THE AM LOOP ANTENNA

CONNECTING AM ANTENNA

Insert into the groove