Nilfisk-Advance America IVB 5-H - Manual (Page 13)

11
english
IVB 3-H
IVB 5-H
IVB 7-H
7.2.2 Replacing the safety
filter bag
1. Clean the filter element (see
4.5 and 4.6).
2. Switch off the vacuum clean-
er and wait approx. 5 minutes
so that the dust can settle in
the tank.
3. Open the retaining clamps
and remove the upper sec-
tion of the cleaner from the
dirt tank.
4. Remove the filter bag con-
nection (1) from the inlet fit-
ting.
5. Close the safety filter bag
connection (2) with the slide.
6. Remove the plastic sleeve
from the tank rim and close it
using a cable binder (3).
7. Remove the safety filter bag
from the tank and dispose
of it in accordance with legal
regulations.
8. Insert a new safety filter bag
into the tank according to the
instructions (in the filter bag
packaging).
IMPORTANT:
Press the filter bag connection
on the inlet fitting as far as pos-
sible.
During the following work, en-
sure that dust is not unnecessarily
spread around. Wear a P2 breath-
ing mask.
3
1
2
3
3
1 1
1 1
2 2
5. Dispose of the dirt in accord-
ance with legal regulations.
6. Insert a new filter bag into the
cleaned tank as described in
the instructions enclosed.
IMPORTANT:
Press the filter bag connection
firmly on to the inlet fitting.
IVB 7-H:
1. Remove the upper section of
cleaner from the dirt tank.
2. Open the retaining clamps
(1) and remove the interme-
diate ring (2) from the tank.
3. Close the waste bag using
the cable binder (3).
4. Dispose of the dirt in accord-
ance with legal regulations.
5. Insert a new filter bag into the
cleaned tank as described in
the instructions enclosed.
IMPORTANT: Press the filter
bag connection firmly on to
the inlet fitting.