Nostalgia Electrics CCM-527 - Manual (Page 5)

4
INSTRUCTIONS FOR USE (Continued)
2. There are two switches on the unit. (See Illustration B, below)
The HEAT SWITCH (left) turns on the heating element, the MAIN SWITCH (right)
turns motor ON and OFF. Make sure you have a flossing cone in hand, switch
to ON position.
Illustration B
Cotton candy floss should be made
within a few seconds.
3. Close dome leaving just enough room to be able to reach inside and spin the
flossing cone. When you can visually see the cotton candy ‘web’ begin, collect the
cotton candy on the cone by holding the cone vertically. Rotate the cone with your
fingers while you circle the bowl. Once cotton candy has collected on the cone,
hold the cone in a horizontal position over the extractor head while still rotating the
cone with your fingers. Continue turning the cone with your fingers while the cone
is in the horizontal position, and move from side to side making sure you are
collecting all the cotton candy.
TIP: If floss does not adhere easily to the cone, you can spray the cone lightly with water.
4. Turn the heat and motor OFF when all the sugar has been dispensed. Once the
extractor head has come to a complete stop, you can pour another measure of
sugar in the extractor head and begin again. The cotton candy should be flowing
more quickly as the unit should be sufficiently warmed up.
NOTES
 Never use ingredients other than pure granulated sugar or flossing sugar. This
will cause clogging.
 DO NOT overfill the sugar receptacle.
 ALWAYS use the protective dome (See Illustration C, below) when using this
machine to protect spectators from hot, sugar particles that may fly out of the
extractor head.
Illustration C
By following these simple instructions, using your OLD FASHIONED CARNIVAL COTTON
CANDY CART™ will be fun for kids of all ages...young or old by bringing a carnival
atmosphere to any occasion!
Display your OLD FASHIONED CARNIVAL COTTON CANDY CART™ with pride and
enjoy some good old fashioned carnival style fun!