Replacing a power supply – Nortel Networks Passport 8001PS User Manual
Page 5
3
5.
Turn on the power switch.
8964FA
Note:
In a chassis that requires more than one power supply (see “Operational Notes”), you
must turn on both units within 2 seconds of each other. If you wait longer to turn on the
second power supply, both power supplies will latch off. To correct this condition, turn off
both power supplies, wait at least 30 seconds, and turn both power supplies on again within
2 seconds.
Replacing a Power Supply
Required tool: Phillips screwdriver
1.
Turn off the power switch on the supply you
are replacing.
2.
Disconnect the power cord from the power
outlet and from the power supply.
8972FA
8962FA