Nilfisk-Advance America 56316025 (R32-C) - Manual (Page 16)

A-16 / ENGLISH
A-16 - 56041647 - Adhancer ™ R28-C, R32-C / BR 800S TRIO EDS ™
SIDE SKIRT MAINTENANCE
The side skirts’ function is to channel the waste water to the squeegee, helping contain the water within the machines cleaning path. During normal use the blades
will wear in time. The operator will notice a small amount of water leaking out underneath the side skirts. A height adjustment can easily be made to lower the
blades so that all the water can be picked up by the squeegee.
To replace the scrub system side skirt(s) ...
1
See Figure 5. Loosen the (2) side skirt Retainer Knobs (A) (2 per side) and pull the Skirt Assemblies (B) off from the scrub deck.
2 Remove the (C) Screws and Nuts, remove the Skirts and replace.
3 Replace the blades as a set if they are nicked, torn or worn beyond their ability to be adjusted.
4 Reinstall the skirt housing assemblies onto the machine and adjust the blade for proper contact to the fl oor when the brush deck is placed in the scrub
position.
SIDE SKIRT HEIGHT ADJUSTMENT
1 The side skirt housing knob retainer screw studs have leveling Adjuster Collars (D), that are to be raised or lowered to compensate for blade wear.
2 To adjust, remove the Skirt Assemblies (B) from the Scrub Deck (E) to access the Adjuster Collars (D). Adjustment Tip: The skirts Retainer Knobs (A) can be
loosened with skirts left on and the Adjuster Collars (D) rotated by reaching under the skirt housing.
3 Turn the Adjuster Collars (D) (Up or Down) to where the blades just fold over enough when scrubbing that all the waste water is contained inside the skirting.
Note: Make small adjustments to obtain good blade wiping. Do not lower the blades too much to where they fold over excessively and cause unneeded
blade wear.
FIGURE 5
revised 2/07