Numark Industries WS32 - Manual (Page 4)

3
Features
1. Frequency Range: VHF 170~250 MHZ.
2. Frequency Stability 0.005% quartz oscillation controlled.
3. Modulation(Max): 30KHZ.
4. Frequency Response:50Hz~18KHz 3dB.
5. Hum & Noise:96dB min.
6. Dynamic Range:100dB min.
7. Distortion:less than 1%.
Wireless Microphone Features and Specification
1. Antenna:built-in with noise terminator circuit.
2. Battery:DC9V.
3. Current Consumption:30mA.
4. Power Output:20mW
5. Spurious Emission:45dB min.
Wireless Receiver Features and Specification
1.Quartz controlled fixed frequency receiving mode.
2.Sensitivity: 10dB/uV(S/N 60dB).
3.Image and Spurious Rejection: min 80dB.
4.Output: unbalanced 0.15V 600 .
5.Receiver System: single channel non-diversity.
6.Power Source: DC 12V.
7.Dimensions: (H)220*(W)124*(D)32(MM).
FEATURES AND SPECIFICATION
5 4
USERS GUIDE
Users Guide
1 Insert adapter DC plug into receiver DC input jack, insert the other AC plug
into AC power supply outlet(According to the sign on the back side).
2 Sound Signal Output Jack: Insert one end of the cable connector plug into
signal output jack at the back of the receiver and the other end of the plug
into KTV or amplifier MIC-IN jack.
3 Push on receiver s power switch, if power LED indicator on front panel
lights, this indicates that receiver works normally.
4 Insert attached 9V battery into wireless microphone's battery compartment
(pay attention to the positive and negative pole), and then close the cover.
5 Turn on microphone power switch, LED indicator will flash once then off ,
it indicates that microphone is ready to use.
6 At this time receiver's RF LED indicator will light. Adjust volume control
to make receiver s volume to be in normal working state. Finish test of
wireless microphone.