Nexgrill 720-0600 - Manual (Page 18)

18
WARNING: IMPORTANT!
BEFORE LIGHTING …
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if
the odor of gas is present. Only the pressure
regulator and hose assembly supplied with the unit
should be used.
TO LIGHT THE MAIN BURNER:
Never substitute regulators and hose assembly for
those supplied with the grill. If a replacement is
necessary, contact the
manufacturer for proper
replacement. The replacement must be that specified
in the manual.
Screw the regulator (type QCC1) onto the tank. Leak
check the hose and regulator connections with a soap
and water solution before operating the grill.
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your grill has an exclusive patented built-in ignition.
The igniter is built in to the valve. To ignite each burner
simply push and turn the control knobs to the HI setting,
you will hear the valve click as it sends a spark to the
pilot flame. If the burner does not light wait 5 minutes
for any excess gas to dissipate and then retry.
WARNING: Always keep your face and body as far
away from the burner as possible when lighting.
TO LIGHT THE SIDE BURNER
To light the side burner, remove any cooking utensils
from the burner grate. Push and turn the control knob
counter - clockwise to the
“IGNITE/HI” position. If the
burner does not light, turn the control knob to “OFF”. If
the smell of gas is detected and the igniter is not
functioning, immediately turn the control knob
“OFF”.
Allow 5 minutes for any accumulated gas to dissipate.
If the side burner igniter is not functioning, see the
following section for match lighting.
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then the
burner can be match lit.
Match light extension rod is located on the inside panel of
the door.
If you ’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated
gas to dissipate. Keep your face and hands as
far away from the grill as possible.
1) Insert a lit match attached to the lighting rod
through the cooking grids to the burner (see
next page)
2) Press the control knob and rotate left to the
HI/Light setting, continue to press the knob
until the burner ignites. Burner should light
immediately.
3) If the burner does not light in 4 seconds turn
the knob off, wait 5 minutes and try again.
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match near the side burner ports,
turn the control knob counterclockwise to
“IGNITE/HI”.
Move your hand immediately once the burner is lit.
Rotate the control knob to the desired setting.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Do not attempt to light the grill if odor of gas is
present. Call for service
1-866-984-7455
Grill Lighting Instruction