beautypg.com

Niles Audio HDL-6 User Manual

Page 11

background image

10

H

I G H

D

E F I N I T I O N

S

P E A K E R

S

E L E C T I O N

S

Y S T E M

3. Make the connections to the HDL-6. The amplifier/speaker
connectors on the HDL-6 are removable. If you wish, you
may remove the HDL-6's connectors to facilitate installation
see (Figure 3). Strip 3/8" of insulation from the end of each
wire. Tightly twist the end of each wire until there are no
frayed ends. Insert each wire into the appropriate hole on
the spring-loaded connector terminals. Be certain that proper
phasing is observed—connect the positive terminals on the
HDL-6 to the positive terminals on the amplifier and speakers
and the negative terminals on the HDL-6 to the negative ter-
minals on the amplifier and speakers. Re-install the connec-
tors if they were removed. See (Figure 4).

4. Locate the pre-printed Room Labels. Affix the appropriate
label to the recessed area over each ON/OFF selector button.

Figure 3

Removing the Connectors

Figure 4

Installing the Connectors