Nady Systems SMA-2130 - Manual (Page 7)

7
S P E C I F I C AT I O N S
EIA Output Power RMS 8
Ω
70W + 70W
1kHz, THD maximum 1% 4
Ω
130W + 130W
8
Ω
Bridged 220W
Less than 8
Ω
Bridged or 4
Ω
Per Side is not recommended.
POWER SPECIFICATIONS
INPUT SENSITIVITY ..............................................................0.77V/26dB/1.4V
INPUT IMPEDANCE ..............................................................20K
Ω
Unbalanced & Balanced
FREQUENCY RESPONSE ....................................................10Hz~50KHz +/-3dB
MAXIMUM INPUT LEVEL........................................................21dB/6V
DAMPING FACTOR (f=1KHz 8
Ω
) ..........................................>150
SLEW RATE ............................................................................35V/uS
DISTORTION ..........................................................................<0.04%
S/N RATIO A-Weighted RMS..................................................>80dB
POWER SUPPLY ....................................................................Voltage selectable 110-120V or 220~240V AC 50/60Hz
FUSES ....................................................................................Standard IEC receptacle with built-in fuse holder
115VAC ~ 5A/250V
230VAC ~ 3A/250V
ELECTRICAL SPECIFICATIONS
GENERAL SPECIFICATIONS
PROTECTION ..........................................................................Full short circuit, current limited, DC fault, AC line fuse, thermal, Power on/off transients,
FRONT PANEL ........................................................................Power switch, Channel 1 and Channel 2 Level controls
REAR PANEL ..........................................................................Stereo/Bridge/Parallel selector, Input Level selector,
LED INDICATORS ..................................................................Channel 1 and Channel 2 Clipping, Protect, Bridge, Parallel, Power
POWER ....................................................................................IEC power cord jack
INPUTS ....................................................................................Active balanced XLR and 1/4" (6.3mm) TRS
OUTPUTS ................................................................................Binding posts/Banana jack, Speakon
DIMENSIONS (WXDXH) ..........................................................19" x 9.84" x 1.73" (483 x 250 x 44mm)
WEIGHT ..................................................................................18.25lbs. (8.28Kg)
The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design
and appearance, are subject to change without prior notice.