Zanussi ZBF 11420 SA - Manual (Page 13)

• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol
are recyclable.
Control panel
1 2 3 4 5
1 Pilot light
2
Temperature regulator
3 Quick Freeze light
4
Quick Freeze switch
5 Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a
medium setting.
The pilot light will light up.
Important! If the temperature inside the
appliance is too high the Alarm light will blink.
Active the Quick Freeze function.
Switching off
To turn off the appliance, turn the Temperature
regulator to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower
settings to obtain the minimum coldness.
• turn the Temperature regulator toward higher
settings to obtain the maximum coldness.
A medium setting is generally the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Quick Freeze function
Press the Quick Freeze switch to activate the
Quick Freeze function.
The Quick Freeze light will light up.
This function stops automatically after 52
hours.
Press the Quick Freeze switch to deactivate the
function at any time.
The Quick Freeze light will switch off.
13
www.zanussi.com