Nostalgia Electrics MARGARITA OASIS MOS-400 - Manual (Page 8)

ENGLISH
6
is an important step in properly repositioning and closing the lid.
Next, make sure the tab extrusion located at the front end of the Lid is 6.
positioned to fit into the groove located at the front inside top of the
Ice Shaving Chamber. The proper insertion of the tab into the groove is
mandatory in order for the ICE SHAVING BLENDER to operate.
The Lid should close and snap shut with the Lid fitting smoothly into place. 7.
Before first use, tighten the Blade Cap by twisting firmly (see 8. Changing
the Blade for location), as it may have become loose during shipping.
The Water Reservoir is located at the back of the Motor Base. 9.
It is removable and snaps in and out for easy cleaning.
Now you are ready to enjoy cold, refreshing margaritas
and drinks from your ICE SHAVING BLENDER!
HOW TO OPERATE
First, find a stable surface near an electrical outlet before 1.
starting. Make sure the cord is away from any water source.
It is acceptable to use an extension cord if needed.
Fill the Pitcher with your favorite liquor, drink mix or fruit. You may choose 2.
to follow one of the recipes included in this Instruction Manual.
Put the Picher Lid on the Pitcher and set the Pitcher in place. 3.
Set aside a dish of ice cubes and allow ice to sit for about 5-10 minutes, 4.
or until ice has slightly melted and does not have a frosty appearance.
Open the Ice Shaving Compartment and make sure 5.
that it is free from any foreign objects.
Add enough ice cubes to reach, but not pass, the max fill line. 6.
Plug in unit while it is in the OFF position. 7.
Turn unit on. 8.
Select blending and ice shaving settings by pushing the buttons 9.
located at the bottom of the ICE SHAVING BLENDER.
Please note that during the first few uses, you may notice a slight 10.
graphite or burning odor. This is common with all new blenders.