Nexgrill 720-0008-T - Manual (Page 11)

10
Lighting instructions
1． Become familiar with safety guidelines at
front of manual. Do NOT SMOKE WHILE
LIGHTING GRILL OR CHECKING GAS
SUPPLY CONNECTIONS.
2． Check to see that cylinder is filled.
3． Check that end of each burner tube is
properly located over each valve orifice.
4． Make sure all gas connections are
securely tightened. TEST FOR LEAKS
WITH A SOAP SOLUTION, NEVER WITH
A FLAME.
(Gas leak Check instructions are on page 1)
5． Always open lid before lighting.
6． Set control knobs to “OFF” and open the
gas supply cylinder valve.
a. Open Lid.
b. Push and turn any Control Knob
slowly to high .The built-in ignitor will click
and spark simultaneously to light the pilot
and burner in sequence. Turn the control
knob to OFF if the burner does not light.
c.
You may have to repeat up to 3 or 4
times to light the burner.
d.
If the burner does not light, turn off
gas and wait 5 minutes for gas to dispel or
before lighting by match.
7. Adjust control knobs to desired cooking
temperature.
NOTE: To light gas grill with a match, follow
steps 1 through 6 above. Then , insert lighted
paper book match with lighting stick through the
cooking grids to the burner. Press in the control
knob and rotate left to “HI” setting to releases
gas. Burner should light immediately.
CAUTION: Do not move grill trolley while in
operation.
If the grill fails to operate properly:
1. Turn off gas at source, turn control knob to
“OFF” and wait five minutes before trying
again.
2. Check gas supply connections.
3. Repeat lighting procedure and if grill still
fails to operate properly. TURN OFF GAS
AT ONCE,TURN CONTROL KNOBS TO:
OFF”, wait for grill to cool and check the
following:
a. Misalignment of burner tube(s) over orifice.
b. Obstruction in gas line from grill.
CORRECTION: Remove fuel line from grill.
DO NOT SMOKE. Open gas supply for one
second to blow any obstruction from fuel
line. Turn off gas supply at
source and reconnect fuel line to grill.
c. Misalignment of ignitor on burner.
CORRECTION: Check for proper position of
electrode tip. The tip of the electrode should be
pointing toward the tip of the collector tube.
The
gap between the spark electrode and the lip of
the gas collector tube should be 3/16”.Adjust if
necessary. With gas supply closed and all
control
knobs set to “OFF” check ignitor for
presence of spark at electrode. In turn push
control knob in fully and rotate slowly about
1¼’’.
turn to the left(counter-clockwise)until a click is
heard; he trigger hitting the strike block should
produce a blue spark at the electrode tip.
If re-ignition is necessary while the gas grill is
still hot, you must wait for a minimum of five
minutes before commencing to re-ignite (this
allows accumulated gas fumes to clear).
If all check/corrections have been made and
gas grill still fails to operate properly, consult
your grill dealer or gas appliance service
person.
FLASH BACK:
When fire occurs in and around the burner
tubes immediately turn off gas at its source and
turn the control knob(s)
to “OFF”. Wait until the
grill has cooled, then clean burner tubes and
burner ports.