ZANKER ZKI1530 - Manual (Page 29)

Fault code and malfunction Possible cause and solution
• continuous flash of the start/cancel
indicator light
• 2 flashes of the end indicator light
The dishwasher will not drain
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose
can be kinked or squashed.
Make sure that the connection is correct.
• continuous flash of the start/cancel
indicator light
• 3 flashes of the end indicator light
The anti-flood device operates
• Close the water tap and contact your local Service Force Centre.
The programme does not start • The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
After the check, switch on the appliance. The pro-
gramme continues from the point of interruption. If the
malfunction shows again, contact your Service Force
Centre.
These data are necessary to help you quickly and cor-
rectly:
• Model (Mod.) • Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
The cleaning results are not satisfactory
The dishes are not clean • The selected washing programme is not applicable for the type of load
and soil.
• The baskets are loaded incorrectly so that water cannot reach all surfaces.
• Spray arms do not turn freely because of incorrect arrangement of the
load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
Limescales particles on the
dishes • The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
The dishes are wet and dull • No rinse aid has been used.
• The rinse aid dispenser is empty.
29