Newer Technology miniStack - Manual (Page 2)

Thank you for purchasing the Newer Technology miniStack!
Please follow this guide to get up and running quickly.
Getting started using your Newer Technology miniStack:
Remove the Newer Technology miniStack from it’s packaging
and examine the back of the enclosure. You will see the following
ports:
On/Off Switch - used to turn the miniStack on. As long as the
power switch is in the ON position, the miniStack will power on
and off with your Mac mini - no need to shut the enclosure off
when done using your mini!
Power Receptacle - used to power the miniStack
Fan Control - The miniStack has 2 speed settings for fan speed,
and an automatic setting (recommended)
USB Ports - add USB devices to your miniStack here
USB Uplink Port - connect your Mac mini to the miniStack here
FireWire Ports- Connect one FireWire port to your Mac
mini using the included cable, and have 2 extra ports to add
peripherals with!
Fan Exhaust Port - Warm air is vented here from your miniStack
Connection Switch - set to Auto, either the USB or 1394
connection will be used to interconnect your miniStack to your
Mac mini. Set to 1394A, the miniStack will always connect using
FireWire (recommended)
Security Slot - Secure your miniStack to your desk using a
Kensington MicroSaver Security Cable (not included)
System Setup:
Your miniStack external drive enclosure and expansion hub is simple
to connect to your Mac mini.
Here are a few tips to get the most out of your new external storage
and expansion device:
• Place your miniStack enclosure underneath your Mac mini
• Do not place anything behind your miniStack that would block
airflow
• Treat your miniStack just like you treat your Mac mini - keep it dry,
cool, and out of direct sunlight
• Always check any peripheral cable that you are going to use with
your miniStack enclosure for damage before hooking them up
Hard Disk Mode:
On the back of the miniStack you will see a switch marked Auto and
1394A. Set the switch to 1394A if you plan to have your Mac mini
hooked to your miniStack all the time and it will automatically use the
FireWire/1394A connection to interface with your internal hard drive
inside the miniStack. If you’re going to use the USB 2.0 connection to
hook up to the hard drive, set the switch to Auto.
We recommend the FireWire connection for maximum speed.
Hub Connection:
To use either the USB 2.0 or FireWire 1394A Hub feature, you must
interconnect the cables provided between your Mac mini and the
miniStack. Connect the FireWire cable between the computer and
enclosure using any of the 3 FireWire ports on the miniStack, and the
one FireWire connection on the Mac mini. The USB 2.0 connection
between the machines is the same, except use the USB 2.0 Uplink port
on the miniStack and any of the 3 ports on the Mac mini.
Fan Settings:
The miniStack has 3 fan modes available for you to select to keep the
unit cool with.
It ships in automatic mode (recommended), or you can set it to full
speed by following these directions:
To set for manual HIGH speed, locate the dip switches on the back of
the enclosure and, using a ball point pen, flip the switch marked “A” (for
Automatic) to “M” for manual. This will turn the unit onto Manual, High
Speed. For manual LOW speed, simply flip the switch from “H” to “L”
using the above instructions for entering manual mode.