Nady Systems 351VR - Manual (Page 4)

(11)
9V Alkaline Battery
7
Opening Battery Compartment
(10)
Battery
Compartment
(14)
Headworn
Microphone
(Note: Microphone elements can easily be destroyed by the buildup of salts and minerals from
perspiration and saliva. It is good practice to put a windscreen on the mic element at all times to
protect it.)
(13)
Lavalier/Lapel
(12)
3.5 mm
Locking Jack
(17)
Audio Input
Level Control
(16)
Battery Indicator LED
(15)
OFF/STANDBY/
ON Switch
WHT-15 HANDHELD MICROPHONE TRANSMITTER
• Features the Nady DM-10D unidirectional neodymium dynamic cartridge
for optimum true sound, maximum feedback rejection and minimal
handling noise
• OFF/STANDBY/ON switch allows convenient audio muting with the
transmitter "ON"
• Low battery LED indicator flashes once for unit "ON"; lights steady for low
battery alert
Operating Instructions
1. Unscrew the BATTERY COMPARTMENT COVER (18) and remove,
exposing the BATTERY HOLDER (19). Insert a fresh 9V ALKALINE
BATTERY (20), observing the correct polarity as marked, and screw the
cover back on to the microphone. Make sure the cover is screwed on
completely. A fresh alkaline battery can last up to 15 hours in use, but in
order to ensure optimum performance, it is recommended that you replace
the battery after every 10 hours of use.
2. Turn on the WHT-15 by sliding the OFF/STANDBY/ON SWITCH (21) to
the STANDBY position (transmitter on, audio muted) or the ON position
(transmitter and audio both on). The BATTERY INDICATOR LED (22) will
give a single quick flash, indicating usable battery strength. In the case of a
dead or low battery, the LED will either not go on at all or will stay on
continuously, indicating that the battery should be replaced with a fresh one.
To preserve battery life, turn the transmitter off when not in use.
3. The microphone is now ready to use. The TX LED (6) on the 351 VR
receiver should now be lit, indicating a received signal from the transmitter.
When ready to speak, slide the transmitter switch to the ON position.
Receiver Volume Control Adjust
Turn volume control on the 351 VR receiver clockwise to near full gain.
Wearing a monitor headset plugged into the receiver's headset jack, speak
into the lavalier microphone. Adjust the receiver's volume to a comfortable
listening level.
Note: Microphone elements can easily be destroyed by the buildup of salts and minerals from
perspiration and saliva. It is good practice to put a windscreen on the mic element at all times to
protect it.
8
351VRman 10/17/01 9:33 AM Page 6