NuTone AB0008 - Manual (Page 4)

2. HOW TO USE POWER BRUSH/WAND
2.1 WAND RELEASE
The power brush is not recommended for use
on bare floors. Wand release pedal (A) on power
brush allows you to quickly disconnect wand
and switch to combination floor/rug tool for use
on bare floors.
2.2 POWER BRUSH NECK RELEASE
Push down power brush neck release pedal (B)
to unlock brush neck. Return the neck to the
upright position for storage.
2.3 POWER BRUSH HEIGHT ADJUSTMENT
The icons (D) refer to the carpet pile height. Select height
by depressing height adjustment pedal (C) to desired position:
(Extra-Low), (Low), (Medium) or (High).
H
EIGHT ADJUSTMENT LED INDICATORS
The LEDs show the carpet pile covered by the selected
height, e.g.: when (High) is selected, all LEDs will be
lit, since this height covers all pile heights. So if
(Extra-Low) is selected, only the lowest LED will be lit.
2.4 WAND LENGTH ADJUSTMENT
Extend (E) or shorten (F) the wand to comfortable
work position by holding the wand grip (G) in
one hand and sliding the upper section (the one
with the prongs) with the other hand.
2.5 EDGE CLEANER
Brush extends full width for effective edge cleaning along both sides of nozzle. To
operate, simply run cleaner along edge board. Rubber bumper protects furniture
and baseboards.
FLOOR HEIGHT
- 4 -
B
C
D
F
E
A
G
CAUTION
Always pick up hard or sharp objects by hand before using your
power brush. Items such as pins, hairpins, tacks, crayons, etc., may
damage the brush roll or may break the belt.
CAUTION
Always unlock brush neck before use.