Nokia Ethernet bridge adapters 100BASE-T - Manual (Page 10)

Product Overview
10 (14) © Nokia Corporation
DN0610789
RX LINK 100 HD
10/100 BASE-T Bridge
Speed Duplex 100 HD
10
100
100
Half
Full
Full Off
Off Off
Off On
On
Figure 9. Front panel E66210.33
RX displays receive status. LED blinks every time when an Ethernet packet is
received from the LAN.
LINK displays link status. LED is lit when cable is connected to another
Ethernet equipment and the link is up. Link status is also shown at the DNT
modem: if the link is down there is no incoming signal alarm.
100 displays speed status. LED is lit when the ET-adapter is configured to
100BASE mode, otherwise the adapter is configured to 10BASE mode.
HD displays duplex status. LED is lit when the ET-adapter is configured to
half duplex mode, otherwise the adapter is configured to full duplex mode.