Nady Systems TMP-1 MICPREAMP - Manual (Page 6)

6
(10) (11) (12)
REAR PANEL
Rear Panel
(10) AC POWER CORD IEC CONNECTOR WITH INTEGRATED
FUSE HOLDER
This standard IEC power cord receptacle is used to connect the
AC power to your unit. It features a built-in fuse holder for a
5X20mm, 0.5A/250V slow-blow fuse. If the fuse continuously
blows, shut off the unit and have it serviced by qualified service
personnel.
(11) AC VOLTAGE SELECT SWITCH
Before plugging in the power cord, check to see that the unit is set
for the proper voltage for your area: ~115V (60Hz) or ~230V
(50Hz).
(Note: Use at the improper voltage can damage your unit and void
the warranty.)
(13)
(12) OUTPUTS
Unbalanced 1/4" (6.3mm) and balanced XLR outputs
(Note: Only one output (1/4" or XLR) can be used at one time. Do
not connect to both at the same time, or the signal will be
severely distorted.)
(13) INPUTS
Unbalanced 1/4"(6.3mm) and balanced XLR inputs.
(Note: Only one input per each channel (1/4" or XLR) can be
used at one time. Do not connect to both at the same time or the
signal will be severely distorted.)
CONTROLS AND CONNECTORS