Identification of controls, Front panel – NAD C515BEE User Manual

Page 7

IDENTIFICATION OF CONTROLS

front panel

1 power: Press this button to switch ON the C 515BEE. The Standby

LED indicator will turn from amber to blue and illuminate the Vacuum
Fluorescent Display (VFD). Pressing the power button again turns the
unit back to standby mode.

The C 515BEE can also be switched ON from standby mode by pressing

[OPEN/CLOSE] or [PLAY] button on the front panel as well as on the
remote control.

If the disc tray is open and the C 515BEE is powered OFF, the disc tray

will draw close and the unit powered OFF.

2 indicator: This indicator will light up amber when the C 515BEE is

in standby state. When the C 515BEE is at ON state, this indicator will
illuminate blue.

3 diSc traY: With the DISC TRAY open, insert a CD or other compatible

media disc face down onto the tray.

“No Disc” appears on the C 515BEE’s VFD if the disc is placed upside

down.

4 remote SenSor: Point the CD 7 at the remote sensor and press the

buttons. Do not expose the remote sensor of the CD 7 to a strong light
source such as direct sunlight or illumination. If you do so, you may not
be able to operate the C 515BEE with the remote control.

distance: About 23ft (7m) from the front of the remote sensor.
angle: About 30o in each direction of the front of the remote sensor.

5 vfd: The Vacuum Fluorescent Display (VFD) provides playback

information, settings and other indicators.

6 plaY: Press to start play or to resume play after Pause. If the disc tray

is open, press this button to automatically close the tray and start
playback if a disc is loaded.

7 pauSe: During playback, press this button to stop playback

temporarily, keeping the optical pickup at its current position on the
disc. To resume playback at the exact point where it stopped, press
[PLAY] or [PAUSE] again.

8 Stop: Press the [STOP] button once to stop playback and re-set the

pickup to the beginning of the disc. The display reverts to showing the
number of tracks and total playing time on the disc. If the C 515BEE
was programmed to play a selection of tracks, the program will be
retained in the player’s memory.

Pressing [STOP] twice at program mode will delete the program.

9 open/cloSe: Press this button to open and close the disc tray. When

in standby, this button will also power ON the C 515BEE and at the
same time open the disc tray.

10 Skip/Scan: Press

to skip forward or

to skip backward a track

or file.

Press and hold

for more than 2 seconds to search up or

down a track. The SCAN

button causes the optical pickup to scan

backwards through the recording at high speed. The SCAN

button

causes the optical pickup to scan rapidly forward through the music.

ANÇ

AIS

ESP

AÑOL

ALIANO

DEUT

SCH

NEDERL

ANDS

SVENSK

РУ

ССКИЙ

C515BEE_eng_OM_v05.indd 7

22/9/07 18:27:48