NHT iW2 - Manual (Page 4)

Packing List:
1 pair of baffles
1 pair of frames
1 pair of metal grilles
2 cutout template/paint shields
iWB mounting bracket includes:
(optional, purchased seperatly)
(1) Mounting bracket
(2) Mounting wings
(4) 5 x 50mm flathead screws
Tools Needed:
#2 Philips screwdriver
Pencil
Tape measure
Utility knife or keyhole saw
Level
Wire strippers
Safety goggles
Protective gloves
3
4
5
6
7
8
9
10
11
3456789
1 0
1 1
1
2
12
13
14
12
12
13
14
iW1 iW2 iW3
Grille
Frame
Mounting Bracket
Mounting
Wing
iWB
(optional)
Baffles
Tech Tips: Pre-Wiring for New Construction
1. For best results, avoid running speaker wire near AC wire, as it may induce a 60Hz hum in the audio signal. It’s a good idea to run
the speaker wire after the AC wiring has already been completed, so that you can route the speaker wire at least three feet away from
the AC wiring. If speaker wire and AC wiring must run parallel, install the speaker wire within a steel conduit. Note that low voltage
wiring (doorbell, intercom, telephone, security, etc.) is unlikely to induce hum and can typically be run parallel to speaker cable with no
detrimental effects.
2. When drilling holes through wall studs or ceiling joists, use a drill bit that is at least as wide as the speaker cable that will be routed
through them. Always drill through the center of the stud or joist. If the hole must be drilled within one inch of the edge of a wall stud,
add a nail plate to the drywall side to protect the cable from possible nails and screws put in the wall later. Line up the holes in the
studs or joists as you go, so that pulling the cable through them will be easier.