NISSAN 2010 Altima Hybrid - Manual (Page 20)

18
HOMELINK ® UNIVERSAL TRANSCEIVER (if so equipped)
SYSTeM OPeRATinG TiPS
Garage doors, electrical gates, entry doors, etc., will be activated during programming. To avoid
injury, make sure that people and objects are clear of all doors or gates during programming.
Your vehicle’s engine should be turned off while programming the HomeLink
® Transceiver.
To program your HomeLink ® Transceiver to operate a garage door, gate, or entry door
opener, home or office lighting, you need to be at the same location as the device.
NOTE: Garage door openers (manufactured after 1996) have “rolling code protection.”
To program a garage door opener equipped with “rolling code protection,” you will
need to use a ladder to get to the garage door opener motor to be able to access the
“smart” or “learn” program button.
PROGRAMMinG YOuR HOMeLink ® uniVeRSAL TRAnSceiVeR
(Mirror, Sun Visor or Overhead console)
1. To begin, press and hold the two outer
HomeLink
® buttons (to clear the memory)
until the indicator light blinks slowly (after
20 seconds). Release both buttons.
2. Position the end of the hand-held transmitter
1-3 in (26-76 mm) away from the HomeLink
®
surface.
3. using both hands, simultaneously press and hold both the HomeLink ® button you want to
program and the hand-held transmitter button. DO NOT release the buttons until step 4
has been completed.
FOLDING DOWN THE REAR SEATS
FROM INSIDE THE VEHICLE
The rear seats can be locked using the mechanical key to prevent
unauthorized access.
Open the access cover and press the release button 01
to fold
down the center/passenger’s side rear seat.
Reach through the opening and pull on the strap 02
located
behind the seat to fold down the driver’s side rear seat.
FROM THE TRUNK
Pull the strap 03
located behind the seat to fold down the center/
passenger’s side rear seat.
Pull on the strap 04
located behind the seat to fold down the
driver’s side rear seat.
01
02
03
04