Nostalgia Electrics Vintage CCP-200 - Manual (Page 9)

ENGLISH
7
Assembly of Wheels
Insert Axle Rod (F) into Base Support (I). 1.
Put on #5 Flat Washer. Slide Wheel (G) into Axle Rod (F) 2.
and add a second #5 Flat Washer.
Use Wrench (H) to tighten the #6 Nut Cup. 3.
Add #5 Flat Washer, second Wheel (G), another #5 Flat Washer, and #6 Nut 4.
Cap to the other side of the Axle Rod (F), following the directions above.
Use Wrench (H) to tighten the #6 Nut Cap. 5.
Assembly of Main Unit
Place Main Unit (A) onto the top of the Storage Compartment (C). 1.
Ensure that the two inserting pins at the bottom of the Main 2.
Unit (A) line up correctly so that Main Unit (A) can be locked
under the beam of the Storage Compartment (C).
(H)
Wrench
(#6)
Nut
Cap
(#5)
Flat
Washer
(F)
Axle
Rod
(G)
Wheel
(I)
Base
Support