Napa Essentials 85-640 - Manual (Page 13)

• •
2.2 BATTERY TYPE SWITCH
Use this switch button to set the type of battery to be charged to one of
the following:
• 12V STANDARD: Use on typical lead-acid batteries (starting and deep
cycle). This type of battery is usually used in boats, cars, trucks, and
motorcycles. These batteries have vent caps and are often marked
“low maintenance” or “maintenance-free”.
• 12V AGM: Use on batteries marked AGM (starting or deep cycle). AGM
batteries have sealed cases without vent caps.
• 12V GEL CELL: Use on batteries marked GEL CELL (starting or deep
cycle). Safe to use on “ALL” batteries.
• 6V STANDARD: This is the type of battery usually used in antique
and some specialized vehicles. The 6V STANDARD battery type is not
selectable for batteries greater than 8.5V DC.
With the exception of AGM and GEL CELL batteries, all other battery
types may or may not have vent caps. Vent caps are located on top of the
battery and provide a means to add distilled water when needed. Batteries
should be marked with their type. If charging a battery that is not marked,
check the manual of the item that uses the battery. If the battery type is
unknown, use the GEL CELL setting.
2.3 CHARGING/STARTING BUTTON
Use this button to set the maximum charge rate to one of the following:
• 2A SMALL BATTERY: Provides 2A for charging small batteries such as
those commonly used in garden tractors, snow mobiles and motorcycles.
The 2A rate is not intended to be used as a trickle charger for larger
batteries.
• 15A<>40A REGULAR BATTERY: Automatically switches between
5 and 40 amps, or provides 5 amps continuous depending on the
battery. Use for charging automotive batteries, marine batteries, and
deep cycle batteries. Not intended for industrial applications.
• 125A ENGINE START: Provides 25 amps for cranking an engine with
a weak or run down battery. Always use in combination with a battery.
• OFF: Charger returns to tester mode and the SMALL BATTERY,
REGULAR BATTERY and ENGINE START LEDs all stay OFF.
13. ASSEMBLING YOUR CHARGER
Included with your battery charger are two cord wrap cleats for storage of
the clamp cables.
To install, align the two tabs to correspond with the two receptacles and
push until you hear a snap.
Wrap clamp cables after unplugging the power cord from the AC wall
outlet and store your charger in a dry location.