Introduction – Nostalgia Electrics Vintage SCM-802 User Manual

Page 4

ENGLISH

INTRODUCTION

Now you can enjoy icy, cool snow cones to snack on when……



Watching TV or a Movie at Home



Throwing a Party



Listening to music



Craving a Low fat Treat

And more…

The SINGLE CONE VINTAGE SNOW CONE MAKER™ is easy to use, just follow these
simple instructions:

After Taking the Unit Out of the Box

Your SINGLE CONE VINTAGE SNOWCONE MAKER™ is already fully assembled.
Before first use, lift the removable top off of the body and wipe clean the inside of
the unit with a non-abrasive moist sponge, a non-abrasive towel, or a damp cloth
followed by a non-abrasive dry towel.

After cleaning the inside, put the top back on the base of the unit.

Now you are ready to enjoy cool, refreshing icy snacks from your SINGLE CONE
VINTAGE SNOW CONE MAKER™.

USING YOUR SINGLE CONE VINTAGE SNOW CONE MAKER™

First, find a stable surface near an electrical outlet before starting. (Make sure your cord is
away from any water source. If needed, it is acceptable to use an extension cord.)

1.

Before plugging in your unit, add ice cubes by removing the clear top from your
SINGLE CONE VINTAGE SNOWCONE MAKER™. In order to do so, turn the
clear top counter-clockwise, lift and remove. Once you have done this, plug in
the unit.

For Optimal Ice Shaving Results – Your ice cubes should sit a short while before putting
them in the shaving unit. If your ice has a frosty look, it is much too hard to shave. If your
ice sits long enough to look clear and it is wet to the touch, then it is ready to make your
SINGLE CONE VINTAGE SNOW CONE MAKER™ experience a fun one.

When ice cubes are ready, place cubes in the shaving unit allowing enough room
for the lid to be placed back on the unit easily.

Place a cone in the snow cone holder so the shaved ice does not spill onto your
countertop.

Return the clear lid to the unit and turn clockwise to the ON position. This will
activate the unit to begin shaving. (To turn “OFF” simply turn the lid counter -
clockwise.)

Repeat steps 3 and 4 until you have shaved the amount of ice desired. Make
sure to unplug when you are finished.

Use the recipes found on the next page to create your favorite snow based
treats!