Philips PD9000/12 - Manual (Page 16)

16
The
»
CHR indicator turns on (red). It takes about 7 hours to fully
charge the battery.
When the battery is fully charged, the
»
CHR indicator turns off.
Install remote control battery
Caution
Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard •
batteries in fire.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
•
equivalent type.
Batteries contain chemical substances, they should be disposed of properly.
•
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/ •
hazardouswaste/perchlorate.
For first-time use:
1
Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
3
Close the battery compartment.
EN