Philips C AZ1021N - Manual (Page 6)

Power Supply General Operation / Tuner
Using AC power
WARNING: Always ensure that you have
completely switched off the set, before
you change or disconnect power supply.
1 Check if the power voltage, as shown on the
type plate located on the bottom of the set,
corresponds to your local power supply. If it
does not, consult your dealer or service cen-
ter.
2 Connect the power cord to the AC
MAINS~ inlet and the wall socket.The set is
now connected and ready for use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
4 Install the unit near the AC outlet and where
the AC power plug can be easily reached.
• Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set.
Helpful hints:
– To avoid unnecessary energy consumption,
always adjust the
Source selector to OFF
after using the set.
General operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector to: CD, or TUNER .
2 To switch off the set, adjust the Source
selector
to OFF position.
Adjusting volume and sound
1 Adjust volume by using the VOLUME con-
trol.
2 Adjust sound effect by using the DBB con-
trol.
Radio reception
1 Adjust the Source selector to TUNER.
2 Adjust BAND to select your desired wave-
band, MW or FM.
3 Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
• For FM, extend, incline and turn the telescop-
ic antenna for best reception and reduce its
length if the signal is too strong.
• For MW , the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
AZ1021_79_CCR 2007.9.19 16:58 Page 6