Switch for ctv receivers tda8440 – Philips TDA8440 User Manual
Page 9
November 1985
9
Philips Semiconductors
Product specification
Switch for CTV receivers
TDA8440
Notes to the characteristics
1. Also if the supply is switched off.
2. Caused by drive on any other input at maximum level, measured in B = 5 MHz, source impedance
for the used input 75
Ω
,
3.
4. Supply voltage ripple rejection = 20
5.
6. Caused by drive of any other input at maximum level, measured in B = 20 kHz, source impedance
of the used input = 1 k
Ω
,
7. f = 20 Hz to 20 kHz.
8. All outputs are short-circuit proof (static).
9. The inputs and output (apart from SDA, SCL and OFF) withstand tests of MIL-STD-883 C. It is advisable to
connected series resistors to these pins.
10. Timings t
S, DAT
and t
H, DAT
deviate from the I
2
C bus specification. After reset has been activated, transmission may
only be started after a 50
µ
s delay.
11. I
2
C bus load conditions are as follows:
4k
Ω
pull-up resistor to
+
5 V; 200 pF to GND.
All values are referred to V
IH
= 3 V and V
IL
= 1,5 V.
Bus free before start
(11)
t
BUF
4
−
−
µ
s
Start condition set-up time
t
s(STA)
4
−
−
µ
s
Start condition hold time
t
h(STA)
4
−
−
µ
s
SCL, SDA LOW period
t
LOW
4
−
−
µ
s
SCL, HIGH period
t
HIGH
4
−
−
µ
s
SCL, SDA rise time
t
r
−
−
1
µ
s
SCL, SDA fall time
t
f
−
−
0,3
µ
s
Data set-up time (write)
t
s(DAT)
1
−
−
µ
s
Data hold time (write)
t
h(DAT)
1
−
−
µ
s
Acknowledge (from TDA8440) set-up time
t
s(CAC)
−
−
2
µ
s
Acknowledge (from TDA8440) hold time
t
h(CAC)
0
−
−
µ
s
Stop condition set-up time
t
s(STO)
4
−
−
µ
s
PARAMETER
SYMBOL
MIN.
TYP.
MAX.
UNIT
crosstalk
20
V
out
V
IN
max
----------------------
log
=
S/N
20
V
O
video noise (p-p) (2 V)
V
O
noise rms B = 5 MHz
----------------------------------------------------------------------
˙
.
log
=
V
r
supply
V
r
on output
-------------------------------- at f = max. 100 kHz.
log
S/N = 20
V
O
nominal (0,5 V)
V
O
noise B = 20 kHz
-------------------------------------------------------
˙˙
.
log
crosstalk = 20
V
out
V
in
max
--------------------- according to DIN 45405 (CCIR 468).
log