ProForm 585 PI User Manual

Page 17

Follow your progress with the LED track and
the four displays.

See step 5 on page 10.

Measure your pulse, if desired.

See step 6 on page 11.

When the program is finished, remove the
key.

Step onto the foot rails and remove the key from
the console. Keep the key in a secure place.

Note:

If the displays and various indicators on the
console remain lit after the key is removed, the
console is in the “demo” mode. Refer to the in-
structions at the right and turn off the demo
mode.

When you are finished using the treadmill, move
the on/off switch near the power cord to the off
position.

THE INFORMATION MODE/DEMO MODE

The console features an information mode that keeps
track of the total number of hours that the treadmill has
been operated and the total number of miles that the
walking belt has moved. The information mode also
allows you to switch the console from miles per hour to
kilometers per hour. In addition, the information mode
allows you to turn on and turn off the demo mode.

To select the information mode, hold down the STOP
button while inserting the key into the console. When
the information mode is selected, the following informa-
tion will be shown:

The DISTANCE/LAPS
display will show the total
number of miles that the
walking belt has moved.

The TIME/INCLINE/MIN-
MILE display will show the
total number of hours the
treadmill has been used.

An “E,” for english miles, or an
“M,” for metric kilometers, will
appear in the SPEED display.
Press the SPEED

▲

button to

change the unit of measure-
ment.

IMPORTANT: The CALS./
FAT CALS./PULSE display
should be blank. If a “d” ap-
pears in the display, the con-
sole is in the “demo” mode.
This mode is intended to be
used only when a treadmill is
displayed in a store. When
the console is in the demo
mode, the power cord can be
plugged in, the key can be re-
moved from the console, and
the displays and indicators on
the console will automatically
light in a preset sequence, although the buttons on the
console will not operate.

If a “d” appears in the

CALS./FAT CALS./PULSE display when the informa-
tion mode is selected, press the SPEED

▼

button

so the CALS./FAT CALS./PULSE display is blank.

To exit the information mode, remove the key from the
console.