Philips HC 070 - Manual (Page 6)

Installation Audio Connections
6
English
Headphone power supply
IMPORTANT
Only use LR03/AAA NiCd batteries
(preferably Philips).
1 Check if the power button of the
IR headphone is in the on position.
2 Ensure the batteries are put in the battery
compartment correctly according to the
engraved polarity symbols.
3 To recharge the headphone’s rechargeable
LR03/AAA NiCd batteries, connect the
charge cable between the headphone and
the transmitter (figure 3).
Note:
Completely flat batteries need
approximately 16 hours to recharge.
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
Headphone battery
replacement (figure 4)
IMPORTANT
Only use LR03/AAA NiCd batteries
(preferably Philips).
1 Remove the earcushions.
2 Take out the batteries and dispose of them
properly.
3 Insert new batteries. Only use LR03/AAA
NiCd batteries (preferably Philips).
4 Make sure the batteries are correctly
inserted as indicated by the engraved
symbols in the battery compartment.
5 Put the earcushions back on the earshells.
IMPORTANT
Before using the IR headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
XP SBC HC 070/00-1 29-08-2001 11:10 Pagina 6