Pioneer DV-868AVi - Manual (Page 90)

Additional information 09
90
En
DVD/CD/Video CD/Super VCD player
Problem Remedy
The remote control doesn't
seem to work. • The CONTROL IN jack on the rear panel is connected: Point the
remote control at the connected component to control this player.
• The remote control is too far from the player, or the angle with the
remote sensor is too wide: Use the remote within its operating range
(see
Using the remote control on page 8).
• The batteries are exhausted: Put in new ones (see Putting the
batteries in the remote control on page 8).
No picture/No color. • Check that the PURE AUDIO indicator is not lit. If it is, press the
PURE AUDIO button ( See also Front panel on page 24).
• Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: Press the
PROGRESSIVE button on
the front panel to set to interlace (the indicator above the button
should not be lit) (see
About progressive scan video on page 26).
• DV-668AV only – When an HDMI device is connected, there is no
output from the composite, S-video, or component video jacks
(only during NTSC disc playback).
Screen is stretched or
aspect does not change. • The TV Screen setting in the Initial Settings menu is incorrect. See
TV Screen on page 62 for how to set it correctly for your TV/monitor.
• If your TV/monitor is connected using an S-video cable, try changing
the
S-Video Out setting (see S-Video Out on page 63).
Picture disturbance during
playback or dark. • This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
• Due to the player’s copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
• The TV system may be set inappropriately. See
Setting the TV system
on page 30.
868en.book.fm 90 ページ ２００３年８月１９日 火曜日 午前９時３０分