Pelco C2946M-D - Manual (Page 24)

24 C2946M-D (6/08)
SYSTEM INFORMATION
Select this option to display the camera firmware information.
Restore Factory Settings
Select this option to reset the camera to the factory default settings. This option clears all saved user-
definable settings, except the following:
• CAMERA SETUP menu: ADDRESS, COM SPEED
• LINE SYNC menu: V-PHASE ADJ
• PIXEL CORRECTION
To restore the camera to the factory default settings, complete the following steps:
1. Select RESTORE FACTORY SETTINGS on the SYSTEM INFORMATION menu. The RESTORE FACTORY SETTINGS menu appears.
2. Select OK. The camera resets all parameters to the factory default settings (except those listed above), and then the MAIN MENU appears.
ALL SETTING ARE
INITIALIZED
OK CANCEL
RESTORE FACTORY SETTING